The HRS 1000-2 is a chamber dryer from the Croatian manufacturer Herbas in which the material dries on trolley shelves. It is designed for fresh plant material, fruit and vegetables and forms part of Herbas lines for medicinal herbs and olive leaf.
How it works
- The material is spread in an even layer on the shelves and the trolleys are rolled into the chamber.
- A fan blows in heated air, which moves horizontally between the shelves, that is, between the layers of material.
- Moisture-laden air leaves through a louvre or a duct, and outside air is drawn in to replace it.
- When the humidity in the chamber falls to the set level, the exhaust damper closes and drying continues on recirculated air.
Balancing dampers set the ratio of exhaust to recirculation. The dryer works in batches.
Control
- Manual: by a thermostat and damper levers.
- Automatic: a controller with servo drives moves the dampers according to the temperature and humidity sensors in the chamber.
Heat sources
- An indirect heat generator on gas or liquid fuel is the standard option: flue gases do not mix with the drying air.
- A water-to-air heat exchanger with an axial fan, where a source of hot water is available.
- An electric heater, which makes sense when the electricity comes from a renewable source.
Construction and specification
| Type | chamber trolley dryer, batch loading |
| Material dried | fresh plant material, fruit, vegetables |
| Air flow | horizontal, between the trolley shelves |
| Body and frame | profiled AISI 304 stainless steel sheet |
| Walls and roof | 50 mm insulating panels with polyurethane foam |
| Trolleys | square tube and AISI 304 sheet |
| Doors | two: at the end and at the side |
We select the chamber size, the number of trolleys and shelves, the load and the heating power for the type and volume of your material.