Herbas RSP continuous rotary drum dryer: indirect heating for grain, seeds and pomace, direct heating for sand, wood chips and sawdust. Sized for your material.
The RSP 600 and RSP 900 are rotary drum dryers from the Croatian manufacturer Herbas. They work continuously: material is fed in at one end of the drum and leaves dry at the other. The machine does not have to stop for loading or unloading.
The dryer is built with indirect or direct heating, depending on what has to be dried.
How it works
The drum rotates, and flights on its inner wall lift the material and shower it through the stream of hot air. This forms a curtain, so the mass is mixed and dries evenly. According to the manufacturer, this allows a higher drying temperature and a shorter drying time without harming the product.
Capacity is controlled by the drum speed (through a frequency inverter), the heating power and the feed rate. Herbas selects the drum inclination, the type of flights and the dimensions for each project.
Manufacturer’s video: Herbas continuous drum dryer
Indirect heating: grain, seeds, pomace
Flue gases do not touch the product: clean heated air enters the drum. It comes from a Herbas HT series heat generator of up to 160 kW burning biomass (wood chips, nut shells, pellets), liquid fuel or gas. An electric heater or a water-to-air or steam-to-air heat exchanger can be fitted instead of it or alongside it. Part of the air is recirculated, and the whole system is insulated.
There is a dual-energy version: an electric heater runs on power from a solar or wind plant, and the heat generator takes over when there is not enough of it.
Direct heating: sand, wood chips, sawdust
For mineral sludge, sand, wood chips and sawdust the flue gases pass directly through the material, which withstands high temperatures and dries quickly. Heat comes from a two-stage burner on liquid fuel or gas, which holds the temperature precisely. Exhaust gases leave through a chimney, and smoke filtration can be added where required.
Manufacturer’s video: drum dryer on quartz sand
Drum and maintenance
The inside of the drum is made of stainless or carbon steel, depending on the temperature, the heating method and the product requirements. Stainless steel is the usual choice for food materials because it is easier to wash. The design has few moving parts, so the dryer is simple to maintain and clean.
Specification
Type
continuous rotary drum dryer
Models
RSP 600, RSP 900
Indirect heating
HT heat generator up to 160 kW, electric heater or heat exchanger
Direct heating
two-stage burner on liquid fuel or gas
Drum material
stainless or carbon steel
Capacity
up to several t/h, depending on the material (manufacturer’s data)
Examples of installed machines
An RSP 600 with direct heating and a two-stage burner dries quartz sand.
An RSP 900 with indirect heating dries grape seeds and pomace: the drum is 13 m long and capacity is about 200 kg/h. A 135 kW electric heater runs in sunny hours, with a 160 kW heat generator as back-up.
Capacity depends on the bulk density of the material and how readily it gives up moisture, so every dryer is sized for a specific job. Send us the material, the initial and final moisture content and the volume you need, and we will prepare an offer.
The KSP 22 is a containerised dryer from the Croatian manufacturer Herbas for medicinal and aromatic herbs. It does not blow moisture out with hot air but condenses it on the evaporator of a refrigeration unit. Drying…
The HKSD is a prefabricated chamber dryer from the Croatian manufacturer Herbas for tobacco, above all the Virginia type. It can also dry other field crops: maize, wheat, peppers. The dryer works in batches.
The HRS 1000-2 is a chamber dryer from the Croatian manufacturer Herbas in which the material dries on trolley shelves. It is designed for fresh plant material, fruit and vegetables and forms part of Herbas lines for…